Description
Aerosol USE ONLY WITH ADEQUATE VENTILATION:
- Shake well before using.
- Hold can 12 in./30cm. from surface to be sprayed.
- Apply a continuous light mist coating to model or mold surface and surrounding forms.
- Using a soft brush, brush the release agent over entire surface of model or mold in order to break the surface tension and minimize air entrapment.
- Apply another light mist coating of release agent and let stand for 5 minutes.
- You are now ready to apply mold rubber or cast into a cured rubber mold.
Liquid Application:
- This product has a limited shelf life and should be used as soon as possible.
- Can be put into non-aerosol plant sprayer, deck sprayer, or applied with soft brush.
- Apply thorough thin coating over entire surface of model or mold.
- Allow surface solvents to evaporate for 5 minutes.
- Compressed air or hair dryer may be used to blow off any excess that has pooled.
- Repeat application and allow to dry.
- You are now ready to apply mold rubber or cast into a cured rubber mold.
Because no two applications are quite the same, a small test application to determine suitability is recommended if performance of this material is in question.