- Soft – Shore 2A hardness allows for softer appliances using less SLACKER™ deadening agent
- Low Viscosity – combined with long working time reduces bubbles and makes pouring easier
- Cures Dry – will not leach silicone fluid
- Long Working Time – 10-12 minute working time is good for larger pours or injections
- Fast Cure – 40 minute cure time allows for quick turnaround of castings or molds
- More Workable – Do More – has a ‘gel’ stage – slushing the material into prosthetic molds is easier
Measuring & Mixing
Before you begin, pre-mix Part B thoroughly. After dispensing required amounts of Parts A and B into mixing container (1A:1B by volume or weight), mix thoroughly making sure that you scrape the sides and bottom of the mixing container several times.
For best results, pour your mixture in a single spot at the lowest point of the containment field. Let the rubber seek its own level. A uniform flow will help minimize entrapped air. If using as a mold material, the liquid rubber should level off at least 1/2” (1.3 cm) over the highest point of the model surface.
Allow rubber to cure for 45 minutes at room temperature (73°F / 23°C) before demolding. Time to demold can be reduced with mild heat or by adding an appropriate amount of Plat-Cat™ cure accelerator (See Plat-Cat™ technical bulletin available at www.smooth-on.com for details). The pot life and cure times can be extended using Slo-Jo™ cure retarder (see Slo-Jo™ technical bulletin available at www.smooth-on.com for details). Do not cure rubber where temperature is less than 65°F / 18°C.